Discounts Of Up to 75% Off On Flash Sale Products Until Supplies Last SHOP NOW

Full Page View
Lookbooks and News
Tags
RECENT POSTS
create Legacy Team1
access_time May 03, 2021
create Legacy Team1
access_time April 21, 2021
create Haus Strom
access_time August 15, 2020
create Haus Strom
access_time March 20, 2020
create Haus Strom
access_time March 19, 2020
create Haus Strom
access_time March 16, 2020
create Haus Strom
access_time March 12, 2020
create Admin Two
access_time March 10, 2020
create Haus Strom
access_time February 28, 2020
create Haus Strom
access_time February 27, 2020
create Admin Two
access_time February 24, 2020
create Haus Strom
access_time February 21, 2020
create Haus Strom
access_time February 18, 2020
create Haus Strom
access_time February 14, 2020
create Haus Strom
access_time February 13, 2020
create Haus Strom
access_time February 11, 2020
create Legacy Team1
access_time February 10, 2020
create Haus Strom
access_time February 06, 2020
create Haus Strom
access_time January 29, 2020
create Haus Strom
access_time January 28, 2020
create Haus Strom
access_time January 24, 2020
create Haus Strom
access_time January 23, 2020
create Haus Strom
access_time May 09, 2018
create Haus Strom
access_time May 08, 2018
create Haus Strom
access_time February 13, 2018
create Haus Strom
access_time November 02, 2017
create Haus Strom
access_time October 02, 2017
Fox Racing: How To Clean a Motorcross Helmet

When the riding is done, it’s easy to overlook helmet care. Your jersey and pants go into the wash easy enough, but what about your moto helmet? As one of your most important pieces of protective equipment, it should be properly maintained. Follow these steps to keep your dirt bike helmet looking and smelling like new.

WHAT YOU’LL NEED

Fox Racing: How To Clean a Motorcross Helmet

CLEAN MICROFIBER CLOTH

Fox Racing: How To Clean a Motorcross Helmet

SOFT BRISTLE TOOTHBRUSH

Fox Racing: How To Clean a Motorcross Helmet

MILD DETERGENT

Fox Racing: How To Clean a Motorcross Helmet

WARM WATER

STEP-BY-STEP INSTRUCTIONS

These instructions are for removing the internals, cleaning interior and exterior, and reinstalling the internals. Every helmet is different, but the steps will be similar. Please consult your owner’s manual for installation of pads and helmet liner.

Fox Racing: How To Clean a Motorcross Helmet
  1. Mix lukewarm water with a mild detergent to create a cleaning solution.
  2. If you have any electronic equipment (GoPro, comms system, etc.), now is the time to remove them.

EXTERIOR

  1. Exterior: Begin by removing the helmet visor. This step gives you a clear surface to clean. Also, removal is the perfect opportunity to inspect the visor and screws. Replace if needed.
  2. Soak a clean microfiber cloth in the cleaning solution and wring out slightly. Ideally, the cloth will be wet but not dripping.
Fox Racing: How To Clean a Motorcross Helmet
Fox Racing: How To Clean a Motorcross Helmet
  1. Gently wipe down the outside of the helmet to remove dirt and grime.
  2. For hard-to-reach areas - such as vents and gasket lining - dip a soft bristle toothbrush into the cleaning solution and brush areas to clean.

INTERNAL PADS

  1. Remove helmet internals: cheek pads and helmet liner.
  2. Carefully handwash each item in the cleaning solution. Massage the pads in the solution to work out sweat and odors.
  3. Gently rinse each item under running water to remove the cleaning solution.
Fox Racing: How To Clean a Motorcross Helmet
Fox Racing: How To Clean a Motorcross Helmet
  1. Squeeze each item to remove excess water and allow to air dry out of direct sun exposure. Tip: Clean your helmet the day before to allow adequate time to dry before your next ride.
  2. Once the helmet liner and pads are dry, reinstall.
  1. Reinstall helmet visor and adjust to your preference.
  2. Take in that new helmet smell & enjoy your next ride!
Fox Racing: How To Clean a Motorcross Helmet

Shop For Fox Racing Helmets

RELATED POSTS